New Cr-01 :) Parts Help/Suggestions please

[pijje1 49]

Hi All

After along time and help from a friend on here I have a Cr-01

 Now I am looking at hot ups lol and electronics so far this is the list so far

Tamiya #54048 - RC CR01 Strengthened Wheel - Axle (2 pcs) x2

Tamiya #54087 - RC CR01 Alum Side Frame 

Tamiya #54105 - RC CR01 Aluminum Skid Plate - For CR-01 Chassis 

 Tamiya #54112 - RC CR01 85mm Steel Prop Shaft - Carbon - For CR-01 Chassis 

Tamiya #54113 - RC CR01 95mm Steel Prop Shaft - Carbon - For CR-01 Chassis 

Tamiya #54206 - RC CR01 Turnbuckle Tie-Rod Set - For CR-01 Chassis x2

Tamiya #54109 - RC CR01 Aluminum Damper Set - For CR-01 Chassis

Tamiya (#54030) CR-01 Setting Stabilizer Set x2

Tamiya (#54047) CR-01 Aluminum Servo Bed x2

Tamiya (#54084) CR-01 Barrel Spring Set x2

Tamiya (#54100) Toyota Land Cruiser 40 Plated Grille

Tamiya (#54102) CR-01 Reinforced King Pin x2

Tamiya (#54103) CR-01 Heat Sink Motor Plate

Tamiya (#54106) CR-01 Bent Lower Arm (Front)

Tamiya (#54107) CR-01 Bent Lower Arm (Rear)

Tamiya (#54111) CR-01 Carbon Mechanism Deck

Tamiya (#53569) Clamp Type Alum Wheel Hub (6MM Thick) 4pcs

Tamiya (#51000) Servo Saver High Torque Type (black)

 

As for Electrics thinking

mtroniks tio rock crawler esc

Etronix ES092 Digital STD Waterproof Metal Geared Servo x2

Tamiya (#54114) CR-Tuned Motor (35T)

 

what do people think ?? or have other ideas or suggestions

 

cheers

paul

 

[pijje1 49]

Hi all 

Any help or suggestions on the hot up front Before I order

Cheers

Paul

[pijje1 49]

Hi all I am building a cr-01 with 4ws and looking for some thoughts on servo arms I have 25t high torque servo the arms I bought are to long and hit the lower steering link the arms I bought are show below and now not sure what to look for

hope to hear your advice  

Paul

[pijje1 49]

Anyone out there that can help ?

[Darat76 265]

would spacing the servo a fraction to clear the links be a possible solution that could allow the use of those servo horns? or perhaps servo's with a shorter height between the mount face tabs and the top of the output shaft?

I have no knowledge of the servo and steering setup on the CR-01, but have noticed some tamiya kits require small changes to allow proper clearance for the steering servo to clear everything, and that many race kits have spacers to get the steering servo in the correct spot for clean steering action.

[pijje1 49]

Hi all this is my part assembled cr-01 think she is looking fab so far

would like to thank people on here for the help and advice and the inspiration to build one

cheers

Paul