Country Mike 120 Posted March 30, 2017 Now apologies if this is in the wrong section or i'm repeating someone else's thread but I've searched and not found anything or my search words are faulty causing the search engine not to chooch. Right, the front hub on the Brat / Orv as an axle what is pressed into the hub and mine pulled out after a good hours worth of fun. I persuaded it back in with a small hammer and all seems well, but I bet it will happen again, so..... Is there any way too mod this with new hubs from another model, or is this an apparent weakness? It's actually a re-release with all these newly re-designed flaws off the old design and six months old. Share this post Link to post Share on other sites
Frog Jumper 3605 Posted March 30, 2017 You could find a Vintage set on EBAY. They didn't seem to have that problem. Or you could try J-Weld or a similar product. There is a thread about that on here somewhere... Or you could modify it with the Blackfoot set up. Terry ETA, I found these... http://www.ebay.com/itm/Tamiya-RC-128-1-10-Racing-Buggy-Upright-Set-Vintage-Frog-MIP-/122419852488 Share this post Link to post Share on other sites
Static Age 65 Posted March 31, 2017 I used Loctite 638 retaining compound, mine have not fallen out since. Share this post Link to post Share on other sites