Juhunio 6830 Posted May 23, 2021 Applies CPR to ancient thread.... I'm sure someone knows....are XV-01 body posts in the same position as TT02/TT01? Ie will pre-drilled TT-02 body shells fit straight onto an XV-01? 1 Share this post Link to post Share on other sites
svenb 3778 Posted May 23, 2021 9 minutes ago, Juhunio said: Applies CPR to ancient thread.... I'm sure someone knows....are XV-01 body posts in the same position as TT02/TT01? Ie will pre-drilled TT-02 body shells fit straight onto an XV-01? Yes they are👍 1 1 Share this post Link to post Share on other sites
svenb 3778 Posted May 23, 2021 1 minute ago, svenb said: Yes they are👍 Want a side by side photo? 1 Share this post Link to post Share on other sites
Juhunio 6830 Posted May 23, 2021 15 minutes ago, svenb said: Want a side by side photo? Ahhh, go on then Share this post Link to post Share on other sites
Juhunio 6830 Posted May 23, 2021 Thanks @svenb , much appreciated Share this post Link to post Share on other sites
GooneyBird 938 Posted May 27, 2021 I love how this thread keeps providing helpful information. 1 Share this post Link to post Share on other sites
mike in pa 64 Posted July 30, 2021 I have a TT02 and I need the rear body posts forward some. Can the plastic body posts be heated up enough to angle them forward or will they break? After they are forward I will be using magnetic mounts on the body posts and can angle them for the roof of the body. Right now the mounts will be right where the rear roof meets the back window. Share this post Link to post Share on other sites
svenb 3778 Posted July 30, 2021 Yes it is possible to bend them with heat, trick is to do it bit by bit and careful with the heat though as they can soon melt. 1 Share this post Link to post Share on other sites