Jump to content
Doc Hollywood

Tamiya Blazing Blazer motor and motor cover wanted

Recommended Posts

Yes it does .

put the old motor in a vice to make life easier for you with pinion sticking up in and clamping against motor body .

use two flat bladed screw drivers inserted under the pinion , then prise each side evenly both the same time and it will lift straight off .

Share this post


Link to post

It’s an interference fit pinion , if you like then put a tiny bit of rod loctite on new motor shaft and tap the new pinion on being sure not to knock on too far and to leave the same gap as like in original motor 

Share this post


Link to post

To avoid damaging the motor when you knock pinion on .

place the bottom of the motor over a vice so the inner shaft sits on it .

so when you tap pinion on your not hitting the shaft inside the motor if that makes sense .

 

Share this post


Link to post

To refitt the pinion you can also press it on with a vice .

if your vice will open wide enough carefully hold pinion over end of shaft and use the vice to compress it together being carefull again not to press it in too far 

  • Like 1

Share this post


Link to post

I’m running the tamiya high torque motor and decided to ditch the original speed controller and use a tamiya ESC also 

22205111-0395-4B9F-8504-7CE178B68D36.jpeg

  • Like 1

Share this post


Link to post
×
×
  • Create New...