nowinaminute 1917 Posted November 17, 2019 15 hours ago, Exmantion said: Hello, I have Nikko f-150 with fried motor, which I would like to replace. Maybe I am a noob in rc cars but my problem is I can't get inside to compartment where motor with gears are. When I undo all screws (which is really hard because wheels block access to them) i can't take left and right parts apart because wheels hold them together, I can only get 2mm of gap between them. I've been looking over internet to find something but I couldn't. I would be very grateful for any help Hi there, This is a later model with a more simplistic chassis. As you have discovered, the wheels aren't held on with nuts like a hobby grade. The motor has a black plastic cover on it. There should be two screws holding that cover on. They are tricky to reach with the wheel on but it can be done. Usually you'll need to use a pair of pliers and a screwdriver bit to create a makeshift right angle screw driver to get into the cramped space. On that cover is off, the motor should come out. It's only held in place by the cover. If you want to get the wheel off there's a little more effort required. This technique applies to most toy grades that have press on collars instead of nuts on axles. You need to support one wheel from underneath and use a hammer and punch to knock the axle out of the bushing. Be careful though, you're obviously risking damaged plastic using this method! Here's a good visual example from when fellow TC member Live Stream Mad took the wheels of his Taiyo Jet Hopper: You need to support one of the wheels 1 Share this post Link to post Share on other sites
Exmantion 0 Posted November 21, 2019 On 11/17/2019 at 2:07 PM, nowinaminute said: Hi there, This is a later model with a more simplistic chassis. As you have discovered, the wheels aren't held on with nuts like a hobby grade. The motor has a black plastic cover on it. There should be two screws holding that cover on. They are tricky to reach with the wheel on but it can be done. Usually you'll need to use a pair of pliers and a screwdriver bit to create a makeshift right angle screw driver to get into the cramped space. On that cover is off, the motor should come out. It's only held in place by the cover. If you want to get the wheel off there's a little more effort required. This technique applies to most toy grades that have press on collars instead of nuts on axles. You need to support one wheel from underneath and use a hammer and punch to knock the axle out of the bushing. Be careful though, you're obviously risking damaged plastic using this method! Here's a good visual example from when fellow TC member Live Stream Mad took the wheels of his Taiyo Jet Hopper: You need to support one of the wheels Yes, Thank you very much! I managed to unscrew this two super hidden screws which I think are really hard to spot without taking the wheels off. Nevertheless, now I will just find some replacement for this motor, which fortunately happened to have something like a nameplate with a model number (RS-880SH RN563Z07, where first 8 might be 3). Thank you one more time Share this post Link to post Share on other sites
KEV THE REV 1300 Posted December 28, 2019 On 11/21/2019 at 10:23 PM, Exmantion said: RS-880SH RN563Z07 It would be RS380SH Share this post Link to post Share on other sites