Servo Saver #51000

[vodka 35]

I have some spares High Torque servo saver, but I have not the Q4 part. I can use only a washer/spacer to lock the servo horn?

 

[waterbok 1282]

I have the q4 on shapeways, those always tend to go missing 

[Juggular 4964]

Depends on the strength, I would suppose.  If you are going to use it for a steering servo for a heavy 1/8, maybe not.  That disc is not flat.  It's got a tubular protrusion going into Q2 or Q5 part.  If you have a tube that can be sandwiched between the washer and Q2, that might work.  

EDIT: If you can get Waterbok's 3D parts, that'd work better! (obviously)  What's your Shapeway ID, Waterbok?  

 

[waterbok 1282]

Q4 shapeways shipping will probably be a spoilsport. I will check if I have spare leftover.

[Juggular 4964]

That link lead me back to the TC Forum page for some reason. 

Edit: found your part: https://www.shapeways.com/product/L5GDLYJSQ/torque-servo-saver-cap?optionId=59115094&li=marketplace

 

 

 

[waterbok 1282]

Just checked, out of spares and in need myself, but 7€ shipping duh. I will wait for the next discount or free shipment offer, if they still do that, and order some.

The hole goes thru the upper arm so you would need small discs and a bigger one to get the right pressure.

 

[Nobbi1977 1793]

I have load of left over bottom parts for the servo type that I never seem to have. Pity they do not put in spare top parts as well