oldtimernola 5 Posted February 14, 2019 Hi there, I have an ad looking for parts to do conversion on my re-re scorcher. I got a good bit of slop out with stiffer rods and dubro connectors. It seems that the stock servo saver hits front cross bar at full right turn and limits it. I have read about this conversion on this site so I plan on doing it. I am close but want to make sure I get every part required correct. I plan on keeping radio box so I will have to travel the body post mount "route" for the conversion. Parts I need are: 1. Vintage Sand Scorcher body post 2. Super Champ servo saver set up 3. Vintage Rough Rider body post As I understand it the vintage SS post goes right on top of vintage RR post, servo saver installed as per normal. How do the post stay together? Am I missing any part of this conversion. Thanks guys for any advise, Regards, LJT III Share this post Link to post Share on other sites
TWINSET 1793 Posted February 14, 2019 On a vintage Sand Scrocher body post, there's a 3mm grub screw at the bottom - this tightens against the RR body post Share this post Link to post Share on other sites
Finman 69 Posted February 14, 2019 I don't believe the Rough Rider body post will fit the Super Champ servo saver, I use a Super Champ Body post (vintage/rere/or remade) with the vintage Sand Scorcher mount. The Sand Scorcher mount has a small grub screw that is tightened on the Super Champ body post. Rich Twinset beat me to it!! 1 Share this post Link to post Share on other sites
oldtimernola 5 Posted February 14, 2019 Ok Thanks, I read something about a vintage RR post in the conversion which confused me because it would have used the sand scorcher saver. So I need vintage Super Champ post or a re-re/fighting buggy post. thank you guys so much, LJT III Share this post Link to post Share on other sites
oldtimernola 5 Posted February 14, 2019 Anyone have a part number for the super champ post or the fighting buggy(rere) post? These seem hard to find. Haven't found any for sale. thanks Share this post Link to post Share on other sites
KEV THE REV 2319 Posted February 14, 2019 1 hour ago, Finman said: I don't believe the Rough Rider body post will fit the Super Champ servo saver, That is why I designed the custom post 1 Share this post Link to post Share on other sites
oldtimernola 5 Posted February 14, 2019 Thank you guys so much. I'm looking for the only part I need now which is the elusive Super Champ post. thanks all again...If anyone sees one point me there:) Cheers LJT III Share this post Link to post Share on other sites
Finman 69 Posted February 15, 2019 Hi LJT III Let me check, I think I have a spare - may even be one of Kev the Rev's custom one's. Where about's in the world are you? Rich Share this post Link to post Share on other sites
oldtimernola 5 Posted February 15, 2019 New Orleans , Louisiana Share this post Link to post Share on other sites