Jump to content
TwistedxSlayer

My TB01 Shelf Queen

Recommended Posts

3 hours ago, vodka said:

It's for the front only.... but fit on rear too, any issue on every day usage?

It's the same front and rear. Don't know about daily usage with it being sat on a shelf. Can't see why it would need to be alloy anyway. Plastic is fine imo.

Share this post


Link to post
Share on other sites
2 minutes ago, Fuijo said:

I was confused by this too. It was @GooneyBirdwho figured it out. If you fit it on the rear it leaves very small gaps where dirt could enter the pinion/spur area. The standard plastic part is longer to block these gaps.

Lol. Well that's not a concern with running the carbon chassis 🤣😂🤣🤣😂

Share this post


Link to post
Share on other sites
27 minutes ago, TwistedxSlayer said:

Can't see why it would need to be alloy anyway. Plastic is fine imo.

Can't see why it would need to be a separate part and not an one block design. :)

Share this post


Link to post
Share on other sites
30 minutes ago, vodka said:

Can't see why it would need to be a separate part and not an one block design. :)

It's a shared gearbox off the TG10. Maybe that's why it's got a separate mount.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...