Frog Front Upright Screws...

[john893 9]

Hello everyone,  I was wondering if anyone has come up with a good replacement screw for a Frog/Brat upright screw.  I looked for bag D online and it's about $12 with shipping, which seems a bit high for just needing one screw.  I know I have lost this screw in the past so I think it's a common issue and was wondering if anyone has a good cheaper solution?

Thanks!

John

[Juggular 4964]

I wonder if regular machine screw with a couple of copper tubings would work?  

It may need one tubing that fits tightly with the screw, and a bigger one over that.  I've done it on smaller screws on non-adjustable linkages that didn't have ball studs.  Never done it for kingpins, so I'm just tossing an idea into the universe, hoping it might help.  

 

[Fuijo 880]

These fit - https://tamico.de/Tamiya-KingPin-4x10mm-5-Stk-50585

 

[Frog Jumper 3658]

Are you in the US???

I'm sure I have one in my Toolbox...  If I do, and you are in the US, I can send you for free + postage...

Terry