I need help for TAMIYA TYRELL P34 1977 MONACO SPECIAL 1/10 2WD please

[spch1960 1]

I have start to build the TAMIYA TYRELL P34 1977 MONACO SPECIAL 1/10 2WD but I have problem in page 13 I cannot fit the two big rear wheels. The shaft is too short to screw the two flange nut in the wheels. Is there some mistake in the TAMIYA manual or some error from my building?

regards

spiros

[mongoose1983 3335]

8 hours ago, spch1960 said:

Is there some mistake in the TAMIYA manual or some error from my building?

It's hard to tell, without any pictures to help and "see" what the problem could be.

Have you checked the position of the wheel-stoppers on your axle?

[spch1960 1]

Dear mongoose1983 thank you for your replay. The position of the wheel-stoppers on the axle is standard there is a cut in the axle.

 

[mongoose1983 3335]

From my end I can't see the specific problem.

What I would do if the car was mine is to disassemble all of the parts of the rear axle and rebuild it all over again following closely the step by step directions in the manual. Perhaps you missed something the 1st time?

I hope you get your axle going this time.

Have a good Thursday!

[spch1960 1]

dear friend I will follow your advice. Thank you for your interested.

Spyros

[mongoose1983 3335]

On 11/14/2019 at 3:34 AM, spch1960 said:

dear friend I will follow your advice. Thank you for your interested.

Spyros

Hi Spyros. Let us know how things went with the rebuilt.

By the way, are your in Greece?

Have a good weekend!

[spch1960 1]

yes sir i live in Athens Greece and the dealer here is very expensive and there is no products in his shop for a long time.