Superluminal 3750 Posted November 14, 2019 Im looking to put some Hornet wheels on another chassis that uses normal hex wheels. I know to do this I need to use the plastic hub adaptors or the die cast ones that the SRB uses. Before I fork out for a hornet B parts sprue or the scorcher metal ones does any one know of a more cost effective solution to get the plastic types on their own? They do come on the wild one and FAV sprues too but the hornet one with the two gearbox halves seems to be the cheapest. Share this post Link to post Share on other sites
KEV THE REV 2319 Posted November 14, 2019 Has the Hex drive car got the drive pins through the axle to accept the Tamiya 5 stud disc ? . Is it a Tamiya hex drive car ? . Share this post Link to post Share on other sites
Superluminal 3750 Posted November 14, 2019 Yes, standard drive pin. Its a Dt02 chassis. Share this post Link to post Share on other sites
KEV THE REV 2319 Posted November 14, 2019 I've got a pair of new Wild One red discs if they are of any use to you ? 1 Share this post Link to post Share on other sites
Superluminal 3750 Posted November 14, 2019 Not half! Share this post Link to post Share on other sites