ernieks 130 Posted December 16, 2019 Hello everyone. I am building an Opel Ascona, but I got stuck. The part G6 is only one time on the G sprue, only 1 G sprue in the kit, but in step 17 it is used 2 times? I don't understand it. What do I get wrong? Any help greatly appreciated. Thank you all. Share this post Link to post Share on other sites
Disco 88 Posted December 16, 2019 It’s because part g6 is used for knocking in the axle tubes without damaging them. 1 Share this post Link to post Share on other sites
martinjpayne 273 Posted December 16, 2019 G6 is just a part to stop you damaging the end of the axle tube when you hammer it into the gearbox half. It is removable and used twice then disposed of... see picture at left hand side of picture 2. 1 Share this post Link to post Share on other sites
ernieks 130 Posted December 16, 2019 Thank you very much! Now I understand. ernieks Share this post Link to post Share on other sites