Tudorp 239 Posted February 13, 2020 ok guys. I am back messing with this stuff after a decades long hiatus. And I am a bit confused. I am building a Sand Scorcher, and am going to use some vintage electronics for it. It is an 80s era Hi-Tec transmitter, receiver and steering servo. And I wired an old Futaba ESC with a comparable plug to plug it into the old receiver. Tested it all, and it is working. However, I just noticed this Futaba ESC does not have a Switch wire to plug into the on/off switch of the car. How do I wire in the on/off switch to turn this thing off without having to disconnect the battery every time? Share this post Link to post Share on other sites