Jump to content
Truck Norris

Part ID - alu rear upright for TRF416?

Recommended Posts

This may be one for TRF guru @qatmix :D

I have a second-hand TRF416 which came with these aluminium rear uprights. I'm not sure which variant of the 416 it is, but I understand they all came with plastic versions of this as standard (51333).

I've searched and not found anything that matches. There's no markings, not even an indicator of toe-in, like on the alu uprights on the 49400 934/TA-05MS I have here. 10mm bearing.

Are they a Tamiya part or something from a third party (Yeah Racing / Jazrider)?

Thanks!

trf416-alu-upright-1.thumb.jpg.c7b39da8a103cd9884a7de7e02d45adb.jpg

trf416-alu-upright-2.thumb.jpg.d68942e84284de88860c559d2a8b9b45.jpg

trf416-alu-upright-3.thumb.jpg.1c648bff110d14530e3b8c500a09aa5e.jpg

trf416-alu-upright-4.thumb.jpg.e27d4b36a5dde003e54ff8563c8b59a4.jpg

Share this post


Link to post
Share on other sites

I don't think they are Tamiya as I never seen the raised section around where the grub screw sits. 

Could be wrong! 

Share this post


Link to post
Share on other sites

3Racing has it - 416-19LB Aluminum Rear Hub Carrier "0" Degree.

3rac-416-19-lb-2-800x800_0.jpg

I used it for my FF-03

ZuANcIeh.jpg

For Tamiya you can use #54137 

tam-54137-002-800x800_0.jpg

Share this post


Link to post
Share on other sites

Thanks guys!

If they're aftermarket then they're not going anywhere near my project :D

I'd seen the TB-03D ones which will fit, but I need zero degree. I guess I could fit 1° then correct back to zero with a narrower rear suspension block.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...