Matty36 267 Posted June 5, 2020 I have purchased the escort cosworth bodyshell, which comes with a 3d printed rear wing. As it sits away from the rear window, has anyone got one and is it best to trim the posts flush so it sits flat to the window, or drill a hole so the post sits through the rear window, as it would basically then be held on with the lower spoiler screws. Share this post Link to post Share on other sites
Problemchild 2149 Posted June 6, 2020 My friend has just done one - I’ll ask him JJ Share this post Link to post Share on other sites
Problemchild 2149 Posted June 6, 2020 He sawed the posts flush, then marked and drilled the holes, then if theres a gap (there is) the screws keep tension against the shell JJ Share this post Link to post Share on other sites