osunick 15 Posted July 8, 2020 I have two of these sets and find them handy for a variety of reasons. The worst part is the blow molded insert that holds the tools in place in the case, so I designed a new one. Hope this is useful to someone. https://www.thingiverse.com/thing:4532536 1 1 Share this post Link to post Share on other sites
futureworks 327 Posted July 8, 2020 That looks excellent, and I'm very familiar with this problem as my insert is gradually disintegrating!. I'm sure many would buy this (if that's what you are offering) so long as it doesn't cost much Share this post Link to post Share on other sites
Manix92 118 Posted July 8, 2020 I'm guessing from pictures on the net the original was vacformed as opposed to blow moulded. Share this post Link to post Share on other sites
osunick 15 Posted July 11, 2020 Ha I am sure you are right. I should know better than to make assumptions about molding techniques in a Tamiya forum. Also, I'm not selling these but anyone with a 3D printer can print one. Share this post Link to post Share on other sites