Jump to content
Sign in to follow this  
Frog Jumper

850 bearing to RC10 wheels???

Recommended Posts

Anybody have any luck getting an 850 bearing to fit the 5/16" (7.937mm) hole in an RC10 wheel???

Being a stupid American, I have no idea what 0.1mm looks like...  

Thanks!

Terry

 

Share this post


Link to post
Share on other sites

They'll squeeze in there if you push hard. But then a 5/16" bearing will be a little sloppy if you try to go back. So if you do it, dedicate a pair of wheels as "metric bearing" wheels.

  • Like 1

Share this post


Link to post
Share on other sites
2 minutes ago, markbt73 said:

They'll squeeze in there if you push hard. But then a 5/16" bearing will be a little sloppy if you try to go back. So if you do it, dedicate a pair of wheels as "metric bearing" wheels.

Ok I’m going to try it...

Share this post


Link to post
Share on other sites

Just get a 5mm reamer and open the hole up. It’s super close so you won’t be removing much material 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×
×
  • Create New...