Frog Jumper 3662 Posted November 5, 2020 Anybody have any luck getting an 850 bearing to fit the 5/16" (7.937mm) hole in an RC10 wheel??? Being a stupid American, I have no idea what 0.1mm looks like... Thanks! Terry Share this post Link to post Share on other sites
markbt73 5316 Posted November 5, 2020 They'll squeeze in there if you push hard. But then a 5/16" bearing will be a little sloppy if you try to go back. So if you do it, dedicate a pair of wheels as "metric bearing" wheels. 1 Share this post Link to post Share on other sites
Frog Jumper 3662 Posted November 5, 2020 2 minutes ago, markbt73 said: They'll squeeze in there if you push hard. But then a 5/16" bearing will be a little sloppy if you try to go back. So if you do it, dedicate a pair of wheels as "metric bearing" wheels. Ok I’m going to try it... Share this post Link to post Share on other sites
Shodog 1835 Posted November 5, 2020 Just get a 5mm reamer and open the hole up. It’s super close so you won’t be removing much material Share this post Link to post Share on other sites