Jump to content
Doc Hollywood

Vintage Big Wig MSC speed controller question

Recommended Posts

Hi All

I recently did some work on a Vintage Big wig for someone as it didn't run properly and it had a lot of other faults. He has just got back in touch and one of the nuts has fell off of the speed controller wires so the question is what size are they as I don't have the car in front of me to have a look at and can I get them from some were.

any info would be greatly appreciated.

Doc :)

Share this post


Link to post
Share on other sites

If it is one of the 2 that hold the contact plate to the servo , then they are M2 mm and are a common size , The Tamiya wheels nuts on SRB's and the like are 2mm

  • Thanks 1

Share this post


Link to post
Share on other sites

The nut is on the speed controller itself it holds the battery leads on the speed controller plungers  I would send a photo of the offending item but I don't have the vehicle . I have attached a pic I found on Google

062.jpg

Share this post


Link to post
Share on other sites

I've just looked at my boxed Super Champ one as it is similar and they look to be M3 'half' nuts , M3 but very thin .

  • Thanks 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...