Vintage Big Wig MSC speed controller question

[Doc Hollywood 156]

Hi All

I recently did some work on a Vintage Big wig for someone as it didn't run properly and it had a lot of other faults. He has just got back in touch and one of the nuts has fell off of the speed controller wires so the question is what size are they as I don't have the car in front of me to have a look at and can I get them from some were.

any info would be greatly appreciated.

Doc

[KEV THE REV 1329]

If it is one of the 2 that hold the contact plate to the servo , then they are M2 mm and are a common size , The Tamiya wheels nuts on SRB's and the like are 2mm

[Doc Hollywood 156]

The nut is on the speed controller itself it holds the battery leads on the speed controller plungers  I would send a photo of the offending item but I don't have the vehicle . I have attached a pic I found on Google

[KEV THE REV 1329]

I've just looked at my boxed Super Champ one as it is similar and they look to be M3 'half' nuts , M3 but very thin .

[Doc Hollywood 156]

Thank you @KEV THE REV your help is much appreciated I will let the owner know

regards Doc