TycoLover 13 Posted January 16, 2021 5 hours ago, KEV THE REV said: I never tried it in mine , but you could possible use Tamiya / other , screw pins if the original knock out pin is 3mm dia. . They could then be unscrewed at any time - no vice injured in the process Thanks for the suggestion. Yes, they are 3mm. Share this post Link to post Share on other sites
KEV THE REV 2319 Posted January 16, 2021 You're pretty handy with the 3D printing - you could probably build your own Hopper Share this post Link to post Share on other sites
GriffX 7 Posted January 17, 2021 front suspension setup for the Tyco Hopper/Bandit chassis for sale on Shapeways https://www.shapeways.com/product/Y8ZUT8XE5/tbb009-02-tyco-bandit-ampro-control-arm-parts Share this post Link to post Share on other sites
TycoLover 13 Posted January 19, 2021 On 1/16/2021 at 9:00 AM, KEV THE REV said: You're pretty handy with the 3D printing - you could probably build your own Hopper It looks like we're sort of getting there, doesn't it? Share this post Link to post Share on other sites
TycoLover 13 Posted January 19, 2021 On 1/16/2021 at 8:26 PM, GriffX said: front suspension setup for the Tyco Hopper/Bandit chassis for sale on Shapeways https://www.shapeways.com/product/Y8ZUT8XE5/tbb009-02-tyco-bandit-ampro-control-arm-parts That's a neat setup. In my case I'm trying to do sort of the bare minimum to make it a functioning car again... Not looking for a whole lot of improvement. I'd complain about the cost of the set on Shapeways, but I just spent most of my Saturday doing the cad work to be able to print a new front plate / bumper assembly, so I must not value my time much. Share this post Link to post Share on other sites
Nostalgia RC 9 Posted April 8, 2022 Would any of you guys be interested in reproduction decals? I design Share this post Link to post Share on other sites