Jump to content
TycoLover

Return of the Turbo Hopper

Recommended Posts

5 hours ago, KEV THE REV said:

I never tried it in mine , but you could possible use Tamiya / other , screw pins if the original knock out pin is 3mm dia. . They could then be unscrewed at any time - no vice injured in the process

Thanks for the suggestion.  Yes, they are 3mm.

Share this post


Link to post
Share on other sites

front suspension setup for the Tyco Hopper/Bandit chassis for sale on Shapeways

https://www.shapeways.com/product/Y8ZUT8XE5/tbb009-02-tyco-bandit-ampro-control-arm-parts

Share this post


Link to post
Share on other sites
On 1/16/2021 at 9:00 AM, KEV THE REV said:

You're pretty handy with the 3D printing - you could probably build your own Hopper ;)

It looks like we're sort of getting there, doesn't it?

Share this post


Link to post
Share on other sites
On 1/16/2021 at 8:26 PM, GriffX said:

front suspension setup for the Tyco Hopper/Bandit chassis for sale on Shapeways

https://www.shapeways.com/product/Y8ZUT8XE5/tbb009-02-tyco-bandit-ampro-control-arm-parts

That's a neat setup.  In my case I'm trying to do sort of the bare minimum to make it a functioning car again...  Not looking for a whole lot of improvement.  I'd complain about the cost of the set on Shapeways, but I just spent most of my Saturday doing the cad work to be able to print a new front plate / bumper assembly, so I must not value my time much.  :lol:

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...