correct ball nut for tamiya cva shocks on sand viper

[nicksincrc 119]

Hi, I'm just looking for a bit of help please. I want to change the step screws that mount the CVA shocks for ball nuts. I looked at the MS version instructions and  it has 3x12mm grub screw and 5mm short ball nuts 9808012 ,but that's is for the df03 aluminium shocks , can I use them for CVA shocks that came with my viper or do I need the standard length ones. Also the MS uses 5x9mm ball connector 9805611 for the lower rear connection ,can I use ball connector instead ? Just not sure 

Thanks in advance 

[TurnipJF 9192]

The CVA shocks use 5mm eyelets, just like the DF-03 aluminium shocks, so any of Tamiya's 5mm ball nuts or ball studs will fit the shock eyelets.

[KEV THE REV 2319]

Beat me to it

[nicksincrc 119]

8 minutes ago, TurnipJF said:

The CVA shocks use 5mm eyelets, just like the DF-03 aluminium shocks, so any of Tamiya's 5mm ball nuts or ball studs will fit the shock eyelets.

Thanks ,I'm was just worried that they wouldn't fit on the short ones as it looked tight, thanks for the help