Willsls1 342 Posted February 25, 2021 1 hour ago, Boomstick said: Thanks, I found it. Ahh I see you got me by 2mph. OK, now its on bro! 1 Share this post Link to post Share on other sites
Boomstick 156 Posted February 25, 2021 1 hour ago, Willsls1 said: Ahh I see you got me by 2mph. OK, now its on bro! Challenge accepted! Btw, that was just a 7 cell hump pack, hobbywing 1060 and traxxas 12t titan motor... There is an adjustable motor plate, mip diff and larger pinions on the way... 1 Share this post Link to post Share on other sites
Boomstick 156 Posted February 26, 2021 Same as above but now with a 16t pinion... And my brushless set up showed up... I'll be installing that later today... 1 Share this post Link to post Share on other sites
Willsls1 342 Posted February 26, 2021 Got the new gears in, new axles, gonna charge up the Lipo and see what I can get later today. Good luck! 1 Share this post Link to post Share on other sites
Willsls1 342 Posted February 26, 2021 Well snap. Race is canceled due to unforeseen snow flurry 1 Share this post Link to post Share on other sites
Boomstick 156 Posted February 26, 2021 2 hours ago, Willsls1 said: Well snap. Race is canceled due to unforeseen snow flurry That's a nice smooth road you have there... Must be nice...lol... Share this post Link to post Share on other sites
Willsls1 342 Posted February 28, 2021 Well better than last run with the new gears but on the 3rd run lost speed then complete stop with motor spinning. Knew right away that l probably forgot to tighten the set screw on the pinion gear. Sure enough that was it. So was probably giving up some speed with that issue as well. 2 Share this post Link to post Share on other sites
Willsls1 342 Posted February 28, 2021 My Bandit did 26mph. Share this post Link to post Share on other sites
Boomstick 156 Posted March 3, 2021 On 2/27/2021 at 10:33 PM, Willsls1 said: My Bandit did 26mph. 1 Share this post Link to post Share on other sites
Willsls1 342 Posted March 4, 2021 3 hours ago, Boomstick said: Well done good sir ! Share this post Link to post Share on other sites
Yonzariq 114 Posted March 4, 2021 I did that once... measure the speed of my XV-01. Felt fast, but only managed to hit up to 32kmh (19mph). Turned out the previous owner used a pinion which was waaay to small, changed it to a correct pinion and immediately bumped it up to 59kmh (36mph) without any temp issues. Still need to measure my DT-03 and Rustler sometimes, both seem to fly pretty good Share this post Link to post Share on other sites