Boomstick 156 Posted February 16, 2021 It seems like all the wheels out there these days are 12mm hex. Well as you know, the Blackfoot isn't 12mm... I found these adapters on eBay and I'm wondering if anyone has any experience with them? https://www.ebay.com/itm/12mm-HEX-Adapter-4pcs-for-TAMIYA-Lunchbox-CW-01-ORV-Monster-Beetle-Big-Foot-/131258088732?_trksid=p2349624.m46890.l49292 Share this post Link to post Share on other sites
Frog Jumper 3662 Posted February 16, 2021 Try this instead??? Terry Share this post Link to post Share on other sites
INhondo 4 Posted February 16, 2021 I've not used them but, if you can ask the seller how wide the adapters are and they match the offset of your wheels I'd say go for it. Share this post Link to post Share on other sites
73robb 132 Posted February 16, 2021 I bought these from a different seller, but they fit well though I haven't run it yet as I'm waiting for some shims to arrive (the fronts are a bit wobbly even when the nut is fully tightened). The width of the front & back wheels is pretty close, but I haven't adjusted my steering rods yet so my front wheels have a toe-out at the minute. The only issue I have to resolve is when the rear suspension is compressed the inside edge of the tyre is very close to the motor wire. I need to see if I have fitted something incorrectly or if not I may have to re-solder the wire to come off the motor sideways to increase clearance. 1 Share this post Link to post Share on other sites