SOLD: Team Durango Big Bore Dampers

[matisse 1581]

Took these off my DT03 (some mods needed to run) as they were great for ground clearance (being a little long) but not idea for race set up.

14mm bore shock bodies, rebuilt with polished shafts

Two sets of spare front springs included as well as alloy caps and a tiny hex driver for the bleed screws

measure 100mm rear and 83mm at the front, so probs be okay for a Top Force/DF01

£30 posted 

[B.RAD 240]

Interested - what mods needed to fit a DT03 please?

[matisse 1581]

4 minutes ago, B.RAD said:

Interested - what mods needed to fit a DT03 please?

Turnbuckles are a must, I don’t think they will fit through the upper arm at this width.

I used the carbon damper stays and had to space the front inner ball out by 1mm and then move the rear link to the back of the hub.  Worked fine, but for a better racing a set up I’d like shorter front shocks. deets on my Aqroshot thread

[B.RAD 240]

Thanks, appreciate the quick and comprehensive reply! Too much mods for me I'm afraid, so I'll let someone else snap up this bargain!

[xray mark 213]

I’ll have those please mate . Can you pm me the PayPal. 

[matisse 1581]

1 minute ago, xray mark said:

I’ll have those please mate . Can you pm me the PayPal. 

Ahhh ****. They just sold i’m afraid.