Rebuild it , make it stronger , make it better
Model: (Click to see more)
58106: Stadium Blitzer
Status: How To Guide
Date: 24-Jun-2010
Comments: 10
Status: How To Guide
Date: 24-Jun-2010
Comments: 10
Hi all this is a nice easy hop up you need is 3mm rod off ebay , ball connectors , 5mm rod ends , 4mm tube from b&q .. you can do this to the front shock tower also ie so you got two did not as i run out of 3mm rod :-0
If you liked those pictures, you should see these...
Comments
sony-sonic
Nice tip! Spose you could also use this on quite a few other cars!
mad maz
Yea you can i done it on my pumpkin , monster beelte , bush devil but since i have found this 3mm threaded rod i have gone mad and whatever i can mod on my other cars i have done or will do as i go
mad maz
I have also used this on steering arms on monster beetle when i mounted the steering servo in the center for better equal steering you can also use the 4mm alloy tube over steering rods for extra strengh also gives it a better look
sony-sonic
Think I might do this mod with the steering arms on my TA chassis/s! And the hornet too as the supplied ones have shown signs of bending!
mad maz
Yes that would be ideal done the same on my brat makes it alot stronger
rizzo rat
That's a real niffty trick! Basic ideas are always the best, great mod thanks for the tip.
Gruntfuggly
Twinset had a good tip: put a nut on the rod before cutting it - then you can re-thread the end you've just cut with the nut...
mad maz
yes very good as i just went at it like a bull so when i cut the rod it was all mashed up so had to file the end square again
Dam 10
Nice strut brace... crackin' idea
Dannie Boy
Hi Maz!
FOUND IT AT LAST, LOL!! Have ya got some 3mm threaded bar yet? If not drop me a note and i'll sort ya some Stainless Mate.
Regards from Dan.
Want to leave a comment?