Brushless Blackfoot
This was the first car i re-bought getting back in to the RC car world. I initially started stock but then looking into the upgrade world decided to upgrade everything i could. This is a brushless 12T motor ESC system with Alloy - Arms (front/rear/upper and lower), C Hub Chubs, Shock Mounts, Knuckle Arms F + R, Chassis not yet installed from Holle who is a member (email - rc.holle@t-online.de ) HPI Racing SS Monster Wheel Rear, Pro-Line Masher 2000 2.2' All Terrain Truck Tyres, Traxxas Servo Saver Large for more stability, upgraded servo - Traxxas High Torque Waterproof Servo E-Maxx, Wheel wideners for more stability and to stop the car from rolling over at top speed from junfac - www.junfac.com , Traxxas E-Revo wheelie bar, Ford focus ST orange for the body paint, tamiya silver/black flame decals, traxxas 2.4Ghz trans/Rcver.
I am running a 4000mAh 2S lipo and it has a faster off the mark speed than the vorza which i have drag raced it with and gives it a good run for its money for a good 15 - 20m
showing 25mm wheel widener
Alloy chassis yet to be installed
Comments
ipkiss
Im after a bit of advice as i am suffering from steering problems since i installed the wheel wideners, the steering is very loose and shaky does anyone have any ideas how to improve and stabilise this problem ?
scottss129
use the servo saver off the boomerang, its stiffer than the blackfoots
ipkiss
Thanks Scottss ill try the boomerang one, i think part of the steering problem is that i have 25mm wheel wideners on at the mo so im going to reduce that to either 19mm or 11mm ill try them both.
scottss129
where did you get that so nice frame set from?????
ipkiss
from another TC member his email is - [Mail me] - if you look at my 4WD BF i have fitted one on that its a really nice chassis well made cost around £75 each
Want to leave a comment?