Gorgeous Raybrig NSX TG10

(9/23) Changed the exhaust up a bit. Going to slide on some 1/4 € fiberglass heat shield over the copper tubing to protect the plastic and lexan. Currently on order from Amazon.

Hi everyone. I am not new to TamiyaClub, but I am finally a member :) I will be adding my collection to my profile, but it will take time.

For now starting off with this gorgeous gem. Picked it up NIB from a seller in Japan. I tracked down and installed quite a few upgrades and I am on the look-out for more. I suspect it will take time. I has the universal swing shafts (long in the rear), kingpins, aluminum C-hubs, aluminum steering set, TG10 special ball differential in the front, carbon fiber top chassis plate, fluorine TRF dampers, and full ball bearings. I recently added the Tobee Craft over-sized heat sink to the FS-12LT, which I picked up on eBay. It is a combination of chrome and purple anodization. It looks amazing with this NSX livery. I rarely run my cars, but I did break this motor in (5-6 tanks through it so far puttin around the driveway).

Thanks and I look forward to any comments!