Juggernaut3 Aluminium chassis

i broke my juggernaut top chassis rail ( the plastic bit) around all four shock mounting holes

the only alternative was to make a new one from off the shelf aluminium section

these are the results

I made the side rails from 20mm x 10mm channel section, the front and rear plates are made from 40mm x 10mm angle section cut and bent and the shock outer supports are also made from the angle section

wieght is about the same but the strength is greatly improved

front corner rear corner outer shock bracket original body fitted

Comments

Neo Kitz

11-Aug-2004

I like it. It takes away that nasty plastic look which the Jugg is known for. Looks like a monster true monster truck now. Suprising what a little bit of fabrication can do to your truck. Why Pay loads of money for something that you can make yourself..

tylerdurden

11-Aug-2004

i must say, you've done a mighty fine job there peter! would you fix mine if i broke it?

Cul-Tech

11-Aug-2004

Looks very stout Peter, nicely done.

mud4fun

11-Aug-2004

Great work, looks far stringer than the original and I always like to see lots of real metal in a truck!

---

Want to leave a comment?

Name

Email

Comment

Confirm Email

Leave Comment