Porsche 911 GT1 on TA02SW

This car was a little bit of work but the TA02 is one of my favourite chassis and worth the time to put a GT1 onto... At first I made the chassis plates out of alum. Then I did the damper stays but I had to have them a little bit lower than stock to fit the GT1 body... ;) I think it came out fine. The wheels are from Kyosho - wide rear ones - with shaped tire inserts.
The Chassis was built up from parts with

Full Ball Bearings,
50473 High Torque Servo Safer,
50705 TA03 Knuckle Arm (black),
50808 TG10 Long Wheel Axle (R),
53056 Pin Type Wheel Adapter,
53127 Skyline Speed Tuned Gear Set,
53152 Short Type Hard Propeller Shaft,
53157 Aluminum King Pins,
53163 On-Road Tuned Spring Set (F&R),
53191 Turnbuckle Tie-Rod Set,
53192 Turnbuckle Upper Arm Set,
53308 Aluminum Servo Stay,
00054871 Wheel Wideners (Carson) (R),
Homemade Hollow Carbon Gear Shafts,
Homemade Aluminum Chassis Plates and
Homemade Aluminum Damper Stays (F&R)