2.2' Wheeled Clod
Carbon fibre copy of the Crawler Store's NN Chassis - http://www.thecrawlerstore.com/NN.htm
Usual kit;
Clod gearboxes, locked up and bearing'd
Kyosho Mag Mayhem motors
Speedmaster ESC
Hobao narrowed wheels, to have Proline Moab tires fitted
Thundertech motor mounts
Inet top link mounts
Traxxas Big Bore 4'' shocks
Dubro ball ends
Towerpro 995MG hi torque servos
Team Associated battery cups
Asymmetric gearing, 9t pinion at front, 10t at rear
Comments
Cul-Tech
Looks pretty good with the 2.2's, ace job on the wiring.
AAAA
Very nicely done Andy! I'm seriously considering buying the double-N kit myself actually - how to the those rim/tyres perform compared to the bigger stuff usually found on these? I'm wondering if Savage rims/tyres (minus foam inserts) might be the way to go? That carbon looks lovely mate!
TWINSET
MadZ; Not sure what they're like on a Clod, no RX in this yet.........
On the TLT the moabs work nice, the Mashers are a similar compound, so should be ok most of the time - They worked great on Willy Rash, but that was without any foam
Savage size will probably be close to Clod, no? - Also, check the rim offset - most other rims have the centre section more towards the outside of the rim - pushing the tires closer to the links and bodywork
Try running w/o foam and also with cut foam; on the TLT I took about 5mm off the OD and 5mm off the ID, then chamfered the corners too - gives support but still allows for cool deformation
Cheers Mike, I'm getting better at it
Rothmans Racing Team
Looks ace that mate! Where will it end?
mr_pushrod
Another cool crawler!
petercabrio
these are starting to make you look like you know what you are doing there bloke.!!! lol
you will soon be getting the crowned CLOD GOD
BiggusDitchus
Great looking truck, is your shell on backwards or tyres on wrong way round?
TWINSET
They looked better that way round, worked good on Willy Rash like that too
backtomyroots.
Once again - Fantastic truck ! Cool looking with the smaller tires too.
Want to leave a comment?