Novak 4.5 is in!!
Just finished the install, best I could do without cutting any wires, everything fits well now, and the driveshaft is clear of wires!! The battery cable runs under it, but is secured with heaps of clearance. Had to gouge out a section of the chassis to give a bit of clearance to the fan as it would hit the chassis and stop!! This will be run tomorrow!!
Clearanced for fan
All squeezed in!!
Reciever is a bit big though......needs changing!!
61,000 rpm of pure grunt!!!
Comments
EGRESS
how are you going to put a body on it? have you cut a hole?
So the fan is sticking out the side of the body? Interesting.
Corpse Thrower
Body fits on ok, the fan is under the body, sucks air from the gap between the chassis and body. At the moment there is a bulge because of all the wiring on the ESC side, shorten the wiring and it will be perfect (I don't want to do this). There is a bigger bulge in the body on the other side because of the servo plugs poking outside the chassis line. This is only because the reciever is too big. Otherwise, no problems, the body will go on and sit correctly.
bugged
Kewl, Cant wait to see a vid
If there`s going to be one ofcoarse ?
Want to leave a comment?