Gecko ProLine Truck Crawler
Finally as finished as I can make a runner... BIG shout out to Jozza for the ProLine truck bodyshell. Now, the photo's don't do the colour justice. It is a candy red backed with silver metal flake paint. It is really pretty!!! :-)
OK, onto the little bits of further information:
Gecko Chassis
Twin Integy Lathe 45t Motors
TTR Eliminator front steering
Inet-RC rear steering
Twin locked diffs (Inet-RC units)
Twin Hitech HS-645MG servo's
ProLine Truck Body
Blue alloy shocks with yellow springs (can't remember make)
Proline Outback Weld rims (also got std clod ones)
Proline Masher yres (also got std clod ones)
Delrin wheel wideners
Futaba 6 channel radio gear (using 3 channels - fwd/rev, front steer, rear steer)
And yes, it is dirty! Had been out running it and it was either pictures now (with a perfect body) or wait until it was clean and possibly less than perfect! ;-)
Comments welcome as always :-)
If you liked those pictures, you should see these...
Clod running on a Gecko Chassis
Comments
TWINSET
Wheels a Proline Welds
Nice body fella, glad to see taste finally reached ya
Lemming
Thanks Andy, both for the information about the wheels and for appreciating my shell choice!
TWINSET
Well, anything's an improvement fella
Hillman666
Yeah definatly agree with Twinset, looks loads better with this body! Like the colour choice too.
Lemming
Got to stop using this red now. Mini, Gecko... Think it's time for purple or yellow candy on the next one!
richytanimal
Very, Very nice job Bruv
djderk
That looks far to nice mate. I think you should sell it to me
jozza
Very nice, glad the truck shell worked out for you, it's a lot better seeing it painted up on a truck rather than sitting in my workshop on a shelf unpainted
Want to leave a comment?