my former racer, I now have a TA05MS
Status: Runner
Date: 7-Jun-2008
Comments: 3
Here is my total new racer, a fully hopped up tt-01r chassis.
What did I change, from 3 racing: chassis conversion, drive shafts, aluminum ball diff front and rear, aluminium rear hub carrier 1degree, alu front steering block, swing shafts front and rear.
From GPM: steering assembly with bearings, alloy full arm set.
From Tamiya: TRF special damper set hard black coating with TRF short springs, medium at front, soft at rear, alloy propeller shaft, turnbuckle tie rod set, motor heat sink, yokomo deep offset wheels (8mm at rear and 6mm at front).
A corally black series rebuildable 27T single wounded.
Off course i am using my spectrum 2.4ghz
And a GM V8rw 8T limit esc
Hope you all like my car and comments are more then welcome.
Update: this is now my former racer
Comments
mikeekim
is there any tt01 left? nice car tho mate, good work
claude
Thanks. the main pinion gear and a few bolts and eeh, thats about it I think :-;
mikeekim
schweet
Want to leave a comment?